If you were holding the servo base and inadvertently pressed the mode button you could have ended up switching the mode by mistake.". Red indicated floor mounted pedals and green is for hanging pedals. This will change the power indicator from red to green and back again. The pedal mode is switched by pressing and holding the MODE button on the front of the steering wheel base. The wheel is able to do this really simply, and unfortunately can happen accidentally. When you do this the gas and clutch signals need to be swapped. The pedals on some Thrustmaster wheels can be flipped upside-down so the pedals hang. Here is the website answer to how to change modes: ![]() In sims I was able to set each pedal, but I do remember them being weird. My memory was thinking it needed to be green, but that was wrong. I did a quick google search, and found that the pedals can be swapped on the wheel by turning the green light to red. Sure enough though the clutch is acting like the accelerate, and vise versa. I went to the control panel, and I don't have it set on "Combined". When reversing the accelerator pedal acts as a brake.įS22 might change this as it introduces gears, which if set to manual might mean you can allocate a reverse gear and have the throttle and brake pedals act normally - there also appears to be a use for clutches. With this disabled you'll have to lift off the brake and then redepress it to reverse. ![]() The brake is also the reverse, but in the in-game "Game Settings" (the escape menu ones) you can disable "Stop and Go Braking", which will stop the vehicle from automatically reversing if you hold the brake pedal down. If you go to the game options (not the ones in the escape menu but the ones on the main menu), go across to "Keyboard Controls" (the third icon) then at the bottom, next to "Back" and "Reset" choose GamePad (or wheel or whatever yours says) and you can set your own controls in there. Ten intensity levels are available: from 1 (minimum intensity) to 10 (maximum intensity), with the default level being set at 5. I assume you don't anyway if you've got the T-LCM pedals, but it's worth checking as that is the default for the regular T300. The intensity of VIPER PANEL’s backlighting can be adjusted directly via the control panel, or via the T.A.R.G.E.T (Thrustmaster Advanced pRogramming Graphical EdiTor) software. I've sold my T300 so I can't check it (I had the T3PA pedals anyway), but make sure your pedals aren't set to combined mode in the Thrustmaster Control Panel (this means if you accelerate and brake at the same time they cancel each other out).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |